SEARCH

Getting Started
1g DSM Datalogging
OBDII Datalogging
Rtek7 ECU Upgrade
PDA Information

PocketLOGGER DSM
PocketLOGGER OBDII
PocketLOGGER ZT
KnockBOX
Rtek7 ECU Upgrade
Jeep Window Block
Hotsync Cables
PL Log Viewer

PocketLOGGER DSM
PocketLOGGER OBDII
KnockBOX
Rtek7 ECU Upgrade
PDA Information
Forum
Ordering/Shipping
Warranty/Returns
Help Ticket
About Us
Contact Us
IMPORTANT
Vacation Closure
Orders including Jeep blocks and parts not including RX7 ECUs between Feb 20th and Feb 27th will not be processed until Feb 27th. All other Rtek orders will be processed normally during this time.

KnockBOX Instructions

KnockBOX™ SA Instructions:

The KnockBOX™ SA is a complete stand-alone system capable of displaying Knock, Timing, and O2, direct from the ECU.

The KnockBOX™ SA comes with three pieces:

  • One - KnockBOX™
  • One - 2 prong power cable
  • One - 6 prong master cable

Installation:

Slave Cable:



Locate the fuse box near the driver's side kick panel. In the upper right hand corner of the fuse box, you will see a black boot covering a connector. Remove this boot by peeling it left to right. Under the boot, you will find the diagnostic connector.


Plug the Slave cable into the connector. It should snap into place. This is a locking connector. It will not fall out. To remove the cable, *first* fully depress the tab on the left side of the connector, and then gently pull the connector out.

Connect the 6 prong connector (located at the other end of the cable) into the back of the KnockBOX™.

Power Cable:

Connect the red power lead to any ignition-controlled power source.

Connect the black ground to any suitable chassis ground.

Connect the 2 prong connector (located on the opposite end of the exposed red/black wires) to the back of the KnockBOX™.

The KnockBOX™ is now ready.

Operation:

Upon powerup, the KnockBOX will go through a brief self-test. It will then display "X.XX YY YY" where X is the firmware version number and Y is either blank or "30 00" if your KnockBOX is for a 3000GT/Stealth.

Once the self-test is complete, the screen should go to all dashes. This indicates that there is no communication. Within 5 seconds, numbers should come up on the display. If they do not, check to make sure the master cable is connected properly.

 

More information:
If you don't know which cars are compatible with the KnockBOX, you can find that information here.

If you are wondering what effects the KnockBOX has on PocketLOGGER datarates, that information is here.

If you need to find what hardware is required to operate the KnockBOX, information and diagrams are here.

If you are looking for installation and operating instructions for the KnockBOX PL (PocketLOGGER version), you can read more here.

Still Lost?:
If you still haven't found what you're looking for, you can take a look at our help section.

Other Products:
KnockBOX
KnockBOX
Price: $175.00


Sitemap  |  Press Room  |  Legal Information  |  Privacy Information

© 2001-2010 digital tuning, inc. All rights reserved.