|
The Rtek7 ECU Upgrade v1.7 for S4 Turbo II cars does seven things:
- Eliminates Fuel Cut ("FCD")
- Allows 720cc secondary injectors to be used without an AFC
- Lowers the secondary staging RPM to 3300 RPM
- Retards timing ~1 degree per PSI above 9 PSI
- Increases the primary injector capacity by 5%
- Allows user to clear engine flood easily
- Eliminates the Accelerated Warm-up System
Built in Fuel Cut Defenser (FCD):
The stock ECU will cut fuel to the rear rotor when boost hits the fuel cut threshold of about 8.6 psi. Although this was put into the stock ECU as a protection mechanism, it's a quite harsh mechanism and not required for mild improvements in boost.
The Rtek7 goes right to the source by removing the code responsible for Fuel Cut from the ECU altogether. This has the additional benefits over external FCDs in that it doesn't alter the boost signal to the in-dash gauge, there are no wires to splice, and no additional box to clutter the engine bay.
RUNNING TOO MUCH BOOST WITHOUT ENOUGH FUEL CAN DESTROY AN ENGINE. EVEN THOUGH THE FCD IS BUILT INTO THE ECU, IT IS THE CUSTOMER'S RESPONSIBILITY TO ADDRESS FUEL REQUIREMENTS SEPARATELY.
720cc Secondary Injectors:
The secondary injectors MUST be at least 720cc or engine damage will result! For version 1.7, the fuel map has been corrected to compensate for larger 720cc secondaries without the need for external fuel control, like an AFC, to keep from running very rich. If you have an AFC, it will no longer have to trick the ECU to compensate for the larger injectors. The AFC can be used for fine tuning. This also means that you CANNOT run version 1.7 in a car with 550cc secondaries or you will run lean.
Lower secondary injection point to 3500:
Normally the secondary injectors start adding fuel at 3800 RPM. The problem is that the secondary injectors will not come on below this rpm regardless of the boost being run. This can lead to cars running lean below 3800rpm even if they have larger injectors, fuel pump etc. Lowering the RPM at which the secondary injectors come on allows them to add fuel before the primary injectors start to max out.
Increase primary injector duty cycle cap by ~5%:
Raising the cap allows a little bit more out of the primary injectors. This works in conjunction with the lower Secondary Injection RPM to smooth out air/fuel ratio and get rid of the lean spot.
Timing retard above 9psi:
The stock ECU has no additional timing control for above around 9-10psi. This mod extends the timing control to give a little more safety for those running 9+ psi. Timing is pulled about one degree per PSI.
Flood Clear:
The Rtek7 Upgrade eliminates the need to pop the hood to pull a fuse when the engine is flooded. Simply press the accelerator to the floor and crank. The ECU will now stop fuel delivery for as long as you keep your foot on the floor.
AWS:
When you first start your RX7, the ECU will rev the engine to approximately 3000 RPM's - this is the Accelerated Warm-up System (AWS) in action. The purpose of the AWS is to warm up the precat. Of course, one of the worst things you can do to a cold engine is high revs. This mod removes the AWS code from the ECU allowing your car to idle normally when cold.
Please join the discussion forum at www.pocketlogger.com/forum
If you have any questions regarding the installation or use of your Rtek7 ECU Upgrade, please contact us at
|
